Front-Wheel Stand - BMW K1300R Manual

Front-wheel stand

Installing front-wheel
stand
The BMW Motorrad front
wheel stand is not designed
to support motorcycles not fitted
with a centre stand or without
other auxiliary stands. A motor-
cycle resting only on the front
wheel stand and the rear wheel
can topple.
Place the motorcycle on its
centre stand or another auxiliary
stand before lifting the front
wheel with the BMW Motorrad

front-wheel stand.

Use basic stand with tool num-
ber (0 402 241) in combina-
tion with front-wheel adapter
(0 402 243).
without centre stand OA
Place the motorcycle on an
auxiliary stand; BMW Motorrad
recommends the BMW Motor-
rad rear-wheel stand.
Installing rear-wheel stand
( 118).
with centre stand OA
Make sure the ground is level
and firm and place the motor-
cycle on its centre stand.
Slacken adjusting screws 1.
Push the two pins 2 apart un-
til the front suspension fits
between them.
Use locating pins 3 to set the
front-wheel stand to the de-
sired height.
Centre the front-wheel stand
relative to the front wheel and
push it against the front axle.
There is a risk of damaging
the sensor ring of the BMW
Motorrad Integral ABS.
Push the left pin in just far
enough to ensure that it clears
the sensor ring.
Push both mounting pins 2
through the triangles of the
brake caliper anchorages just
far enough to allow the front
wheel to be rolled between
them.
8
117
z