Installing Front Wheel - BMW K1300R Manual

Installing front wheel

8
Possible malfunctions when
ABS and ASC systems in-
112
tervene if non-standard wheels
are installed.
See the information on the effect
of wheel size on the ABS and
ASC systems at the start of this
chapter.
Threaded fasteners not
tightened to the specified
torque can work loose or their
threads can suffer damage.
z
Always have the security of the
fasteners checked by a specialist
workshop, preferably an author-
ised BMW Motorrad dealer.
The front wheel must be
installed right way round to
rotate in the correct direction.
Note the direction-of-rotation ar-
rows on the tyre or the wheel
rim.
Roll the front wheel into posi-
tion between the front forks.
Raise the front wheel, insert
quick-release axle 3 and tight-
en to specified torque.
Quick-release axle in
threaded bush
50 Nm
Tighten right axle clamping
screw 2 to the specified tight-
ening torque.
Clamping bolt in wheel
carrier
19 Nm
Remove the front-wheel stand.
OA
without centre stand
Remove the rear-wheel stand
with BMW Motorrad Integral
ABS II OE
Insert the ABS sensor into its
bore and install screw 1.