Record; Schedule - Digimerge DH200+ Series Instruction Manual

Using the Main Menu

RECORD

Configure recording parameters for
each channel.
Figure 15.0 Record menu
To configure recording settings:
1. Press to select a camera you wish to
configure.
2. Press to select an option and the
+ -
press / to configure the following:
• CONTI. (Continuous recording): Select
continuous recording frame rate (1~30 fps)
• QUALITY: Select LOW, MIDDLE, HIGH,
SUPER, and ULTRA.
• MOTION: Select ON/OFF. Motion Grid and
sensitivity must be configured in the Motion
menu. See "CONFIGURING MOTION" on
page 27.
• ALARM: Select ON or OFF to enable or disable
alarm recordings.
3. Press to save your settings. Press
ENTER
to close remaining menu
CANCEL/ESC
windows.
Setting Motion-only &
Continuous + Motion (C+M) Recording
• For details on how to set the system
record only when motion occurs,
see "Setting Motion-only
Recording" on page 18.
• For details on how to set the system
to record in Continuous + Motion
mode, see "Setting Continuous &
Motion Recording (C+M)" on
page 20.
28

SCHEDULE

Set four recording modes in a daily
or weekly schedule.
Daily has priority over a Weekly
NOTE:
schedule.
Figure 16.0 Alarm Setup
To set a recording schedule:
1. Press to select MODE1 (red), MODE2
(orange), MODE3 (green), or MODE4 (blue).
2. With a mode selected, configure the
following:
• USE: Select ON/OFF. If OFF, the selected
camera(s) will not record.
• QUALITY: Select LOW, MIDDLE, HIGH,
SUPER, and ULTRA.
• RATE: Select 1, 2, 3, 4, 5, 6, 7, 10, or 15 fps.
• MOTION: Select ON/OFF. Motion Grid and
sensitivity must be configured in the Motion
menu.
3. Select the CHART tab and select ALL,
SUN, MON, TUE, WED, THU, FRI, or SAT,
and press the ENTER button or +/-. The
Schedule sub-menu opens.
4. Enter BEGIN and END times, and select
the MODE for ten time slots.