Volkswagen Golf Variant 2007 Workshop Manual page 31

– To enable clutch to find its installation position already, turn
clutch against puller -T10373- by hand.
• Now turn clutch by hand, without using a tool.
In this way, clutch slides against retaining ring. Do not use any
other tool.
Pressing on causes "clutch to locate at bottom" on input shaft.
Clutch should only be pulled up far enough for it to contact re‐
taining ring.
Then insert hub.
Hub has a "large" tooth and therefore only fits in one position.
"Large" tooth has a mark on -engine end- -arrow-.
Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤ , Jetta 2011 ➤
7-speed dual clutch gearbox 0AM - Edition 07.2010
1. Removing and installing the dual clutch
27