Adding A Rate To A Submaster - ETC Express 24/48 User Manual

Adding a rate to a submaster

160
Rate allows you to record submasters that play back faster or slower than
their recorded fade times. This can be especially helpful when you are
trying to calculate complex timing information for effects loaded to a
submaster.
Note: If you adjust the rate on a submaster containing an effect, the rate
adjustment affects individual step timing but does not change the overall
effect timing.
Rate is expressed as a percentage. A submaster with a rate of 100 plays
back at its recorded fade time. A rate of 300 plays the submaster back
three times faster than its recorded fade time. A rate of 50 causes it to
play back half as fast as its recorded fade time. You may assign a rate of
up to 2,000 percent.
To add a rate to submaster 7, follow these steps:
Action:
1. Press [Blind].
2. Press [Sub] [7].
3. Press [S5], Rate.
4. Press [1][5][0].
5. Press [Enter].
3.
If you do not enter a dwell time for a submaster, the submaster
defaults to a manual dwell.
Keystrokes:
Selects Blind display mode
Prompt reads:
Select submaster number
To select submaster type, press
TYPE
Prompt reads:
Use keypad to select submaster rate
(0 to 2000, 100 = Normal)
Corner reads: Rate 150
Rate of 150 percent is recorded into
submaster 7
Chapter 13 Submasters