Mitsubishi Eclipse Workshop Manual page 269

MANUAL TRANSMISSION
- Transmission Assembty
22-11
q*
o
o
SERVICE POINTS OF REMOVAL
4.
DISCONNECTION OF CLUTCH RELEASE CYLINDER
FROM TRANSMISSION ASSEMBLY
Remove
the
clutch release cylinder and clutch oil
line
bracket installation bolt, and then secure at the body side
without
disconnecting
the oil
linä
coupling.
10.
REMOVAL OF UNDER
COVER
Lift the
vehicle before removing the
under
cover.
12. DISCONNECTION OF
TIE ROD END FROM
KNUCKLE
Using
the
special tool. disconnect the tie rod end from the
knuckle.
Caution
1.
Be sure
to tie
the
cord
of the
special
tool
to
thc
nearby part.
2.
Loose
the nut but do not
remove it.
14. DISCONNECTION OF
LOWER
ARM
BALL JOIIIT
Using
the
special
tool, disconnect the lower arm
ball
joint
from the
knuckle.
Caution
1.
Be sure
to tie
the
cord
of the
special
tool
to
the
nearby part.
2. Loose
the nut but do not
remove it.
15. DISCONNECTION
OF
DRIVE SHAFT
(1)
Insert a pry bar between the transmission case and the
drive shaft, and then pry the drive shaft from
the
transmission.
Caution
1.
Do
not pull on the
drive shaft; doing so will
damage the
inboard
joint;
be sure
to
use
the pry
bar.
2.Do not
insert
the pry
bar so deep as
to
damaged
the oil
seal.
.,i.
(2)
Keep
the
removed drive shaft as
far
away
from
the
transmission case as possible, and secure (by
using
rope. etc.) the joints to the body
so
that it
does not fall.
I
I
,
I
Drive
shafr
I
I
Pry
bar
PWUE9010