Quadra-Fire GRAND BAY 40 GB40FS Installation, Operation, Venting And Maintenance Instructions page 17

3. Place right twig on front and rear
log using ceramic pins and place-
ment holes in bottom of twig for
alignment. (If ceramic pins are too
close, tilt front log forward, do not
make new holes in twigs.) Repeat
step for left twig.
4. Place ember nuggets across front of
burner.
5. Light appliance and let logs cure for 30 minutes. Adjust shutters to give good flame
characteristics.
NOTE: If flame tips have dark yellow or black tips, shutters need to be opened.
6. After correct flame adjustment has been achieved, cool appliance, remove twigs and front log
and tighten shutter adjustment screws.
IMPORTANT: If shutter adjustment screws are not tightened, expansion and contraction of
burner can allow shutter to close and cause sooting.
January 2000
Grand Bay 40 Gas Freestanding
INSTALLING THE LOG SET
Page 17