Exmark lazer z Operator's Manual page 21

For Exmark Mower Parts Call 606-678-9623 or 606-561-4983
4.1.5 Clean muffler and rear frame area:
4.1.6 Clean rear screen in the hood:
c) For 52" units only - Inspect the belt position on the idler arm.
The idler arm may become bent during use or transport. A bent idler arm
could cause the belt to jump off of the idler and be damaged.
1) Make sure the belt cover is installed and run the blower for one to two
minutes.
2) Shut off the deck drive, stop engine , wait for all moving parts to stop
and remove key. Engage parking brake. Remove the belt cover and
check to make sure that the belt is riding near the center of the flat idler on
the idler arm.
3) If the belt is not riding near the center of the idler, remove the blower, and
bend the idler arm slightly.
4) Reinstall the blower and belt cover and repeat steps 1-3 until the belt is
positioned near the center of the idler.
POTENTIAL HAZARD
♦ Operating engine parts, especially the
muffler, become extremely hot.
WHAT CAN HAPPEN
♦ Severe burns can occur on contact.
♦ Debris, such as leaves, grass, brush, etc.
can catch fire.
HOW TO AVOID THE HAZARD
♦ Allow engine parts, especially the muffler,
to cool before touching.
♦ Remove accumulated debris from muffler
and engine area.
♦ Install and maintain in working order a
spark arrester before using equipment on
forest-covered, grass-covered, brush-
covered unimproved land.
Open hood and remove clippings that are stuck to screen.
www.mymowerparts.com
FIGURE 6
WARNING
16