Exmark lazer z Operator's Manual page 14

For Exmark Mower Parts Call 606-678-9623 or 606-561-4983
3.3.5 Unlatch the front end of the blower. Pivot the blower back and lift it off the deck.
3.3.6 Install the discharge chute using the chute pivot pin and hairpin (see Figure 3).
3.3.7 Re-install the plastic belt cover and tighten the knobs.
3.3.8 Remove the hair pins and clevis pins holding the hood assembly to the mount
3.3.9 Lift the bag and hood assembly off the mount.
3.3.10 The removable weights must be removed from above the caster wheels (and front
Note: The removable weights are heavy. Use care when lifting them. Make sure that
Note: The portions of the Ultra Vac QDS bagger that are not bolted to the mower
22
weldment.
of floor pan on some units). To remove the caster weights, loosen the clamping
knobs until the weight can be moved relative to the caster arm. Remove the
hairpins and clevis pins that hold the weights to the caster arms. Carefully lift the
weights off of the caster arms.
To remove the weight on the front of the floorpan, remove the 2 hairpins that
retain it and then lift the weight from the mount plates.
The weights and brackets bolted to the floor pan remain on the unit.
you can hold them securely before lifting them. Use caution when positioning
your hands so that you do not set them down on your hands or fingers.
are designed to be installed or removed in their entirety. Failure to do so
will cause a reduction in stability or traction. Do not operate the mower
with only a portion of the Ultra Vac QDS installed.
www.mymowerparts.com
21
FIGURE 3
9