Bagger Installation For Bagging - Exmark lazer z Operator's Manual

For Exmark Mower Parts Call 606-678-9623 or 606-561-4983
3.3.11 The machine can now be used for side discharge mowing.

3.4 BAGGER INSTALLATION FOR BAGGING

3.4.1 Stop engine, remove key, and wait for all moving parts to stop. Engage parking
3.4.2 Remove hairpin and chute pivot pin. Remove discharge chute. Pivot pin and hair
3.4.3 Install the bagger assembly (Item 7) onto the mount by slipping the hook portion
3.4.4 Install the bag assemblies (Item 1) by inserting the hook portion into the slots in
All units:
3.4.5 Mount the blower on the deck by sliding the mounting pin into the tube at the rear
3.4.6 Pull the spring loaded idler back and slip the belt over the top spindle deck
3.4.7 Install the plastic belt cover (Item 10). On 60" and 66" units the outside end of the
On Units > 600,000 with Triton decks:
3.4.8 Adjust position of dog leg baffle to match the intake of the Ultra Vac blower.
POTENTIAL HAZARD
♦ Caster or front floor pan weights installed
without bagger may cause Loss of
Traction and Steering control.
WHAT CAN HAPPEN
♦ Loss of control can result in an accident,
which may cause Death, Injury, or
property damage.
HOW TO AVOID THE HAZARD
♦ Install caster or front floor pan weights
ONLY when bagger is installed.
brake
pin may be stored in the pivot holes of the discharge chute during bagging
operation.
over the top mounting tube of the mount weldment. Secure the assembly to the
mount using the clevis pins (Item 19) and hairpins (Item 20).
the cross bar of the hood assembly.
right corner of the deck. Swing the blower closed. Adjust the position of the front
pin to engage the slot in the front of the deck. Use the latch to lock the blower in
this position. Adjust the tension on the latch to hold the blower up to the deck, yet
allow for release by hand.
sheave.
cover is slotted and can slip between the two washers on the belt shield stud.
The plastic knob does not need to be removed. On 72" and 52" units the cover
has a hole, and the plastic knob must be installed after the cover has been
positioned. The original belt cover stud must be removed on 52" units.
Baffle adjusted too wide may allow objects to be thrown from under deck. Baffle
adjusted too narrow may cause plugging issues.
www.mymowerparts.com
CAUTION
10