Exmark lazer z Operator's Manual page 16

For Exmark Mower Parts Call 606-678-9623 or 606-561-4983
All Units:
3.4.9 Slip the upper end of the tube assembly into the hood opening. Slide the lower
3.4.10
3.4.11 Install a clevis pin (Item 19) and hairpin (Item 20) on each caster weight to retain
3.4.12 Tighten knob on weight assembly until the weight is clamped securely to the
POTENTIAL HAZARD
♦ An uncovered opening can expose the
operator and bystanders to blade contact
and thrown debris.
WHAT CAN HAPPEN
♦ Blade contact or thrown debris can cause
serious injury or death.
HOW TO AVOID THE HAZARD
♦ Adjust dog leg baffle to match blower
intake opening.
end of the tube assembly over the blower outlet and align the notch with the tube
latch. Latch the tube to the blower.
Note: The removable weights are heavy. Use care when lifting. Make sure
that you can hold the weight securely before lifting. Use caution when
positioning your hands so that you do not set the weight down on your
hands or fingers.
Install the removable weight assemblies over the caster arms. On 52" and 60"
Lazer Z machines one weight has a wide mounting bracket and one has a narrow
bracket. They will only fit the machine one way. Weights for the 60" Lazer XP,
60" Lazer XS and all 66" and 72"s are interchangeable left and right.
them.
caster arm.
www.mymowerparts.com
WARNING
FIGURE 4
11