Operation; Safety Precautions; Graphic Symbols; Definitions Of Welding Modes - Lincoln Electric POWER FEED 10M Operator's Manual

B-1

SAFETY PRECAUTIONS

Read this entire section of operating instructions
before operating the machine.
WARNING
ELECTRIC SHOCK can kill.
• Do not touch electrically live parts
or electrodes with your skin or wet
clothing.
• Insulate yourself from the work and
ground.
• Always wear dry insulating gloves.
• Do not use AC welder if your cloth-
ing, gloves or work area is damp or
if working on, under or inside work-
piece.
Use the following equipment:
-DC manual (stick) welder.
-AC welder with reduced voltage
control.
• Do not
removed.
• Disconnect input power before servicing.
-----------------------------------------------------------------------
READ THIS WARNING, PROTECT YOURSELF &
OTHERS.
FUMES AND GASES can be
dangerous.
• Keep your head out of fumes.
• Use ventilation or exhaust at the arc,
or both,to keep fumes and gases from
your breathing zone and general area.
WELDING SPARKS can cause fire
or explosion.
• Do not weld near flammable material.
• Do not weld on containers which have
held flammable material.
ARC RAYS can burn.
• Wear eye, ear, and body protection.
ONLY QUALIFIED PERSONS SHOULD INSTALL,
USE OR SERVICE THIS EQUIPMENT. READ AND
FOLLOW THE MANUFACTURER'S INSTRUC-
TIONS, EMPLOYER'S SAFETY PRACTICES AND
MATERIAL SAFETY DATA SHEETS (MSDS) FOR
CONSUMABLES.
-------------------------------------------------------------

OPERATION

operate with panels
POWER FEED ® 10M SINGLE WIRE FEEDER
GRAPHIC SYMBOLS THAT APPEAR ON
THIS MACHINE OR IN THIS MANUAL
WIRE FEEDER
POSITIVE OUTPUT
NEGATIVE OUTPUT
PROTECTIVE
GROUND
WARNING OR
CAUTION

DEFINITIONS OF WELDING MODES

NON-SYNERGIC WELDING MODES
• A Non-synergic welding mode requires all welding
process variables to be set by the operator.
SYNERGIC WELDING MODES
• A Synergic welding mode offers the simplicity of
single knob control. The machine will select the cor-
rect voltage and amperage based on the wire feed
speed (WFS) set by the operator.
COMMON WELDING ABBREVIATIONS
WFS - (Wire Feed Speed)
CC - (Constant Current)
CV - (Constant Voltage)
GMAW (MIG) - (Gas Metal Arc Welding)
GMAW-P (MIG) - (Gas Metal Arc Welding)-(Pulse)
GMAW-PP (MIG)-(Gas Metal Arc Welding)-(Pulse-on-Pulse)
GTAW (TIG) - (Gas Tungsten Arc Welding)
SMAW (STICK) - (Shielded Metal Arc Welding)
FCAW (Innershield or Outershield) - (Flux Core Arc Welding)
HF - (High Frequency)
CAG - (Carbon Arc Gouging)
B-1