Examples Of Connecting An Arclink Power Wave System - Lincoln Electric POWER FEED 10M Operator's Manual

A-14
EXAMPLES OF
ARCLINK POWER WAVE SYSTEM
ArcLink Power Wave ® products may be configured in
many different ways. The flexible system allows multi-
ple wire feeders to be connected to the same power
source. The diagrams represent some of the common
methods for connecting ArcLink Products.
Important: Bench model wire feeders cannot be sepa-
rated into a separate control box and wire drive for a
boom system.
Common ArcLink Systems
The following Power Wave
assembled without any changes to the equipment DIP
switches
Basic Semi-Automatic System
• Great for general fabrication.
Shown with
• K2230-2 POWER FEED
• K2203-1 Power Wave ®
Robotic/Semi-Automatic System
• Use the bench feeder for offline welding.
Shown with
• K2230-2 POWER FEED
• K1780-2 PF-10/R
• K2203-1 Power Wave ®
• K2205-1 Wire Drive Module
INSTALLATION
CONNECTING AN
® systems may all be
® 10M Single Wire Feeder
455M/STT
® 10M Single Wire Feeder
455M/STT
POWER FEED ® 10M SINGLE WIRE FEEDER
Hard Automation System
Shown with
• K2657-1 Control Box
• K1780-2 PF-10/R
• K2203-1 Power Wave ®
• K2205-1 Wire Drive Module
Multiple Wire Feeder System
• Load one feeder with solid wire, the other with flux
cored.
• Great for pipeline work.
Shown with
• K2429-1 ArcLink T Cable Connector
• K2536-1
• K2536-1 Power Feed ® 25M
• K2203-1 Power Wave ®
ArcLink Systems
Many other ArcLink systems may be assembled
besides those shown in this manual. The majority will
self configure. If an assembled system flashes the sta-
tus light green rapidly on all components, contact the
Lincoln Electric Company for further assistance.
Current Power Feed ® 10M models that will not self
configure...
• K2316-1 Power Feed 10M Dual Boom
These configurations will require Dip Switches to be
set. See the power source instruction manual on how
to disable self configuration.
A-14
455M/STT
455M/STT