®
MAGNUM PRO
CURVE HDE FCAW HYPERFILL
CONNECTION TO FEEDER
Connection To Power MIG® Series, Power Wave®
Gun cable assemblies which were assembled with a K466-6,
Connection Kit will connect easily to a feeder.
a. Check that the adapter and feeder outgoing guide, as
well as the drive roll, are appropriate for the electrode
size being used.
b. Fully push the brass connector end of the gun cable into
the outgoing side of the feeder wire drive. Secure the
cable using the hand screw on the wire feeder.
c. Insert the control cable plug from the feeder trigger
circuit into the mating socket on the gun cable
connector handle.
Connection To Lincoln 10 Series Feeders
Gun cable as semblies which were assembled with a K466-10
Connection Kit will connect easily to a 10 Series feeder.
a. Check that the K1500-2 gun adapter is in place on the
wire feeder. Check that the feeder guide tubes, as well
as the drive roll(s), are appropriate for the electrode size
being used.
b. Fully push the brass connector end of the gun cable into
the gun adapter on the outgoing side of the feeder wire
drive and secure the cable using the hand screw.
c. Insert the control cable plug from the feeder trigger
circuit into the mating socket on the gun cable
connector handle.
A-6
INSTALLATION