Suzuki VL1500K5 Supplementary Service Manual page 83

82 VL1500K5 ('05-MODEL)
"C31" (P0705) GP SWITCH CIRCUIT MALFUNCTION
DETECTED CONDITION
No Gear Position switch voltage.
Switch voltage is not within the following range.
Switch voltage > 0.6 V
ECM
GP
INSPECTION
Step 1
1) Remove the secondary gear case cover.
(!VL1500 Service Manual 3-7)
2) Turn the ignition switch OFF.
3) Check the GP switch coupler for loose or poor contacts.
If OK, then measure the GP switch voltage.
4) Support the motorcycle with a jack.
5) Fold the side-stand to up position.
6) Make sure the engine stop switch is in the "RUN" position.
7) Insert the needle pointed probe to the lead wire coupler.
8) Turn the ignition switch ON.
9) Measure the voltage at the wire side coupler between R/B
wire and B/G wire, when shifting the gearshift lever from 1st to
Top.
" GP switch voltage: 0.6 V and more
# 09900-25008: Multi-circuit tester set
09900-25009: Needle pointed probe set
) Tester knob indication: Voltage (+)
To engine stop switch
GP switch
BI
N
R/B
R
5
4
B
B/G
3
(+ R/B – - B/G)
POSSIBLE CAUSE
• Gear Position switch circuit open or short.
• Gear Position switch malfunction.
• ECM malfunction.
Side-stand relay
1
Neutral indicator
light
2
Side-stand switch
1
1
Ignition
switch
V