Suzuki VL1500K5 Supplementary Service Manual page 57

56 VL1500K5 ('05-MODEL)
Step 2
1) Turn the ignition switch OFF.
2) Disconnect the TP sensor coupler.
3) Install the test harness to the TP sensor.
4) Check the continuity between terminal A and ground.
" TP sensor continuity: ∞ Ω (Infinity)
5) If OK, then measure the TP sensor resistance at the test har-
ness terminals (between terminal A and terminal B).
6) Turn the throttle grip and measure the resistance.
" TP sensor resistance
Throttle valve is closed:
Throttle valve is opened: Approx. 4.41 kΩ
7) If OK, then measure the TP sensor resistance at the test har-
ness terminals (between terminal c and terminal D).
" TP sensor resistance: Approx. 4.66 kΩ
# 09900-25008: Multi-circuit tester set
09900-28630: TPS test wire harness
) Tester knob indication: Resistance (Ω)
Are the continuity and resistance OK?
YES Go to Step 3.
• Reset the TP sensor position correctly.
NO
• Replace the TP sensor with a new one.
8) After repairing the trouble, clear the DTC using SDS tool.
(!Page 42)
(Terminal A – Ground)
Approx. 1.12 kΩ
(Terminal C – Terminal D)
2
2
2
BI/B
TPS
B/Br
2
2
BI/B
TPS
B/Br
R
ECM
R
ECM