Refrigerator Door - Jenn-Air JWC2450ARB Service Manual

Installation
Wood Screws
1. #8 pan head wood screws are recommended to
properly secure the custom wood panel to the

refrigerator door.

2. A total of 10 screws are needed.
3. Use only pan head screws.
4. Be sure the screw length is NOT longer than the
wood thickness at the screw locations.
5. Use the following pilot hole drill sizes.
Type of
Wood
Hardwood
Softwood
Prepare the Wood Panel
(60.3 cm)
10 Pilot Hole
Locations
30 5 "
⁄
16
(77 cm)
Inside of Door
7
, cont.
Pilot Hole Drill Size for
#8 Pan Head Wood Screws
3 " (.23 cm)
⁄
32
5 " (.20 cm)
⁄
64
23 3 "
⁄
4
Custom panel
thickness:
(1.6-1.9 cm)
Attach the Wood Panel to the
Refrigerator Door
1. Place the custom wood panel on a non-abrasive
surface, protected by towels or rugs, to avoid
accidental damage to the door finish.
2. Place the refrigerator door flush with the inside
surface of the custom wood panel. Clamp the
wood panel to the door, if necessary.
3. Mark the hole locations with a pencil.
4. Drill the pilot holes into the custom panel.
5. Insert the wood screws through the back of the
door and into the pilot holes in the custom wood
panel and tighten.
6. Reinstall the door seal by pressing it into the door
channel, making certain the corners are fully
inserted.
7. Install the door back on the refrigerator using the
supplied plastic washers (as shown below).
8. Realigning the door may be necessary (see page 6).
5 " to 3 "
⁄ ⁄
•
Door can become disengaged if washers are not
8 4
installed.
•
Door may not swing properly if all nylon components
are not installed as shown.
Top Hinge Corner
Bottom Hinge
Corner
Cabinet Hinge
CAUTION
Cabinet Hinge
Shoulder Bushing
Door Hinge
Door Hinge
Shoulder Bushing
Washer
(Optional)
Washer