Jenn-Air JWC2450ARB Service Manual page 27

Installation
Reversing the Glass Door
•
To avoid electrical shock which can cause personal
injury or death, disconnect power to the wine chiller
before reversing the door.
The wine chiller door can have a left or right hand
swing. Typically the door is installed on the wine
chiller with a right hand swing configuration. To
change to a left hand swing, follow the instructions
listed below.
Materials Needed
• 1 " Allen wrench
⁄
8
• Phillips screwdriver with magnetic tip
• Needle-nose pliers
• 5 " nut driver
⁄
16
• Small flat-blade screwdriver
Black or white framed model:
• 15 mm deep-well socket and wrench
Custom wood frame or stainless steel frame overlay model:
• 15 mm open-end wrench
1. Note the thermostat control knob setting so you
can reset the thermostat knob to its proper setting
after the door reversal is complete.
2. Turn the thermostat control knob counterclockwise
until the "OFF" setting is at the 12:00 position. The
wine chiller's refrigeration system will shut off.
3. Using the 1 " Allen wrench, remove the screw from
⁄
8
the top hinge of the wine chiller. Be sure to
support the door so that it does not fall. Lift the
door gently up and away from the bottom hinge.
4. Lay the glass door face down on a smooth, non-
abrasive surface protected by towels or rugs to
avoid accidental damage.
5. Using the 5 " nut driver, remove the
⁄
16
screws which are holding the top and bottom
hinges. Set screws and hinges aside for later.
6. Using the Phillips screwdriver, remove the Phillips
head hinge pin from the bottom hinge. Set the
hinge, hinge pin and plastic washer aside for later.
For custom wood frame model, skip to step 12.
7. Pull the door gasket out of the door's back frame,
enough to allow access to the screw holes and the
back of the door lock.
5
, cont.
WARNING
5 " hex head
⁄
16
Lock body
Key
8. Using the Phillips screwdriver, remove the Phillips
screw at the end of the door lock. Set the Phillips
screw lock washer, lock cam and lock/cam
extension pieces aside for later.
9. Stainless steel frame overlay model only: Remove
the ten screws that secure the stainless steel frame
overlay to the glass door. Set the screws aside for
later.
10. Black or white framed model: Use the 15 mm
deep-well sock and wrench.
Stainless steel frame overlay model: use the 15 mm
open-end wrench.
Loosen the retaining nut that secures the lock to
the door frame. If the nut falls back into the door
frame, use the needle-nose pliers to retrieve it and
set the nut aside for later.
11. Gently lift the door end up where the lock is
currently located and let the lock fall out and away
from the door. Set the lock aside for later.
12. Using the Phillips screwdriver, remove the two
screws holding the light striker plate to the back
side of the door.
The following graphic shows the striker plate hole
locations when changing to a left hand door swing.
Remove the light switch striker from the bottom of
the right hand swing door and install the striker
plate in the holes as shown.
5 " (0.4 cm) diameter
⁄
32
two holes, striker plate
(Back view of glass door)
Lock cam
Phillips
screw
Lock
extension
Glass
door
Door
gasket
Lock retainer nut
Door
gasket