Level The Refrigerator - Jenn-Air JWC2450ARB Service Manual

Dimensions
Front
3"
(7.6 cm)
Side
min. 34"
(86.4 cm)
30 5 " max. 35"
⁄
16
(77 cm)
(88.9 cm)
leveling
legs fully
extended
23 7 "
⁄
8
(60.6 cm)
47 1 "
⁄
4
(120.0 cm)
22"
(55.9 cm)
24 1 "
⁄
4
(61.6 cm)
Leveling Legs
Install leveling legs (located in literature pack):
• At least 2 people are needed to tip the refrigerator
backwards until there is approximately 12" (30.5 cm)
of clearance between the floor and the refrigerator.
with
Leveling Leg
(4 per refrigerator)
• Screw one front leveling leg into the screw
impression found in each corner. Leveling legs
should be screwed in until snug.
• Repeat the above procedures to install the rear
leveling legs.
•
To prevent injury, one person should not attempt to
tilt the refrigerator by himself. Have someone else
assist to prevent the refrigerator from falling during
leveling leg installation.
• The refrigerator should remain upright at least
30 minutes prior to plugging it in.

Level the Refrigerator

Using a carpenter's level, check to be sure the
refrigerator is level from side to side and from front to
back. Leveling adjustments can be made by turning
the leveling legs counter-clockwise to increase height
and clockwise to decrease height.
NOTE: The refrigerator should not wobble. Use shims
to add stability when needed.
Weldnut
(each bottom
corner of
refrigerator)
Bottom of
Refrigerator
WARNING
CAUTION
4