Developer Assembly - Tektronix PHASER 780 Service Quick Reference Manual

Developer assembly

1. Open the front cover. Remove the toner cartridge of the developer
assembly to be removed. Remove the imaging unit.
2. Remove the top cover and inner cover.
3.
Remove the screw securing the carousel latch to the front of the printer
frame. Remove the latch.
4. Turn the carousel knob until the large shoulder screw, securing the
desired developer assembly to the carousel frame, appears through the
access hole a few inches above the carousel knob.
5. Remove the shoulder screw securing the developer assembly to the
carousel frame. Keep the carousel in this position.
6.
Reach in through the top of the printer; slide the developer assembly to
the front of the printer to free the gears at the rear of the developer
assembly.
7.
Lift the front of the developer assembly to free the front of the assembly
from the front of the printer frame. Remove the assembly. Each
developer is keyed to its position in the carousel.
Service Guide
99