Philips MultiOne User Manual page 59

User Manual
failures
EOL driver arcing failures
EOL lamp arcing failures
EOL driver failure lamp
voltage
EOL lamp failure Lamp
voltage
Driver ignition timeouts
Lamp ignition timeouts
Cycling driver failures
Cycling lamp failures
Extinguished failures driver
Extinguished failures lamp
Mains high failures
Mains low failures
Bus failures
Vmid failures
Short circuits
ZCD failures
Over Power Protection
failures
Invalid lamp table failures
a) lamp replacement triggers an erase of predefined lamp-specific items such as ignition attempts, lamp errors.
Diagnostics for a LED device might look as follows:
© Philips Lighting B.V. 2014
operation of the lamp, since last lamp replacement
End-Of-Life situation showing an arcing mode of
operation of the lamp.
End-Of-Life situation showing an arcing mode of
operation of the lamp, since last lamp replacement
End-Of-Life situation showing a lamp voltage level that
was out of operating range.
End-Of-Life situation showing a lamp voltage level that
was out of operating range, since last lamp
a)
replacement .
Failed to successfully ignite the lamp.
Failed to successfully ignite the lamp, since last lamp
a)
replacement .
Cycling of the lamp (extinguished for more than N
times subsequently) [where N depends on lamp type].
Cycling of the lamp (extinguished for more than N
times subsequently), since last lamp replacement
[where N depends on lamp type]
Detection of an extinguished lamp.
Detection of an extinguished lamp, since last lamp
a)
replacement .
Mains voltage level detected that was too high to
continue operation.
Mains voltage level detected that was too low to
continue operation.
Bus voltage level detected that was out of operating
range.
Midpoint voltage level detected that was out of
operating range.
Short circuit detected in the lamp connection.
Critical failure detected in lamp or driver.
Over power detected.
HID driver switched-on with a non-supported or
corrupt lamp table selected.
Philips MultiOne
a)
a)
a)
.
Page 59 / 81
.
.