Titan TTB285JSW Operating Manual page 5

100816_TTB285JSW_Jig Saw-EN-08.pdf
ADDITIONAL SAFETY INSTRUCTIONS FOR YOUR JIG SAW
1. Hold power tool by insulated gripping surfaces, when performing an operation
where the cutting accessory may contact hidden wiring or its own cord.
Cutting accessory contacting a "live" wire may make exposed metal parts of the power
tool "live" and could give the operator an electric shock.
2. Always use eye glasses and dust mask.
3. Hearing protection should be worn when using jigsaw.
4. Do not use damaged or worn blades.
5. Always use jigsaw with guard cover down.
6. Regularly check the two screws in the blade clip.
7. Regularly check the adjustment of the support roller.
8. Do not run the machine with any part of the casing missing or damaged.
9. If blade is jammed in work piece, do not start the jigsaw.
WARNING! Some dust particles created by power sanding, sawing, grinding,
drilling and other construction jobs contain chemicals known to cause cancer, birth
defects or other reproductive harm. Some examples of these chemicals are:
• Lead from lead-based paints.
• Crystalline silica from bricks and cement and other masonry products.
• Arsenic and chromium from chemically treated timber.
Your risk from these exposures varies, depending upon how often you do this type of
work. To reduce your exposure to these chemicals:
• Work in a well ventilated area.
• Work with approved safety equipment, such as those dust masks that specially designed
to filter out microscopic particles and use the dust extraction facility at all times.
SAFETY POINTS FOR YOUR LASER
Do not stare directly at the laser beam. A hazard may exist if you deliberately stare into the
beam, please observe all safety rules as follows:
1. The laser device fitted to this tool is class 2 with a maximum radiation of 1mW and
650nm wavelength. These lasers do not normally present an optical hazard although
staring at the beam may cause flash blindness.
2. The laser shall be used and maintained in accordance with the manufacturer's instructions.
3. Never aim the beam at any person or an object other than the work piece.
4. The laser beam shall not be deliberately aimed at another person and shall be prevented
from being directed towards the eye of a person for longer than 0.25 seconds.
5. Always ensure the laser beam is aimed at a sturdy work piece without reflective
surfaces, e.g wood or rough coated surfaces are acceptable.
Bright shiny reflective sheet steel or similar is not suitable for laser applications as the
reflective surface may direct the laser beam back at the operator.
6. Do not change the laser device with a different type. Repairs must be carried out by the
manufacturer or an authorised agent.
CAUTION! Use of controls or adjustments other than those specified herein may
result in hazardous radiation exposure.
JIG SAW 750W
5 8/16/10 2:04 PM
TTB285JSW