Adjustment Mode - Star SP712 Series Hardware Manual

Dot printer

Hide thumbs Also See for SP712 Series:

Table of Contents

5-4. Adjustment Mode

There are the following seven adjustment modes.

The device will enter the adjustment mode if your turn it on while pressing the FEED switch.

(1)

The Self Printing Mode is entered by releasing the FEED switch after the buzzer sounds once. (Refer to Section

"5-4-1. Self Printing Mode".)

(2)

Adjusting the Dot Alignment Mode is entered by releasing the FEED switch after the buzzer sounds twice. (Refer

to Section "5-4-2. Adjusting the Dot Alignment Mode".)

(3)

The Hexadecimal Dump Mode is entered by releasing the FEED switch after the buzzer sounds three times. (Refer

to Section "5-4-3. Hexadecimal Dump Mode".)

(4)

The Black Mark Sensor Alignment Mode is entered by releasing the FEED switch after the buzzer sounds four

times. (Refer to Section "5-4-4. Black Mark Sensor Alignment Mode".)

(5)

The Near End Sensor Adjustment Mode is entered by releasing the FEED switch after the buzzer sounds five

times. (Refer to the separate Specifications Manual for details.)

(6)

The Memory Switch Manual Setting Mode is entered by releasing the FEED switch after the buzzer sounds six

times. (Refer to the separate Specifications Manual for details.)

(7)

The Memory Switch Override Mode is entered by releasing the FEED switch after the buzzer sounds seven

times. (Refer to the separate Specifications Manual for details.)

(Holding down for 2 more seconds)

Returns to (1).

– 25 –

Table of Contents

Show Quick Links

Table of Contents

Sp742 series