Adjustment Mode - Star SP712 SERIES Hardware Manual

Dot printer

Hide thumbs Also See for SP712 SERIES:

Table of Contents

6-4. Adjustment Mode

There are the following seven adjustment modes.

The device will enter the adjustment mode if your turn it on while pressing the FEED switch.

(1) The Self Printing Mode is entered by releasing the FEED switch after the buzzer sounds

once. (Refer to Section 6-4-1.)

(2) Adjusting the Dot Alignment Mode is entered by releasing the FEED switch after the buzzer

sounds twice. (Refer to Section 6-4-2.)

(3) The Hexadecimal Dump Mode is entered by releasing the FEED switch after the buzzer

sounds three times. (Refer to Section 6-4-3.)

(4) The Black Mark Sensor Alignment Mode is entered by releasing the FEED switch after

the buzzer sounds four times. (Refer to Section 6-4-4.)

(5) The Near End Sensor Adjustment Mode is entered by releasing the FEED switch after the

buzzer sounds five times. (Refer to the separate Specifications Manual for details.)

(6) The Memory Switch Manual Setting Mode is entered by releasing the FEED switch after

the buzzer sounds six times. (Refer to the separate Specifications Manual for details.)

(7) The Memory Switch Override Mode is entered by releasing the FEED switch after the

buzzer sounds seven times. (Refer to the separate Specifications Manual for details.)

(Holding down for 2 more seconds)

Returns to (1).

– 24 –

Table of Contents

Show Quick Links

Table of Contents

Sp742 series