Table of Contents
Advertisement
CONNECTION
Video output, e.g., VCR
Composite
Y/C
Y/C
Y/C
Composite
Output
Video output, e.g., VCR
Output signal
When BR-DV6000 enters the STOP, REC or
EDIT mode, the input signal (E-E image) is out-
put. In the PLAYBACK mode (including the play-
back of the pre-roll part during editing), play-
back images are output.
However, in the edit mode with analog input,
signals cannot be output to the DV OUT termi-
nal properly.
● Analog signal
• LINE OUT terminal (BNC): composite signal.
• Y/C OUT terminal (4-PIN): YC separate sig-
nal.
When a wide screen ID signal exists in the
video signal, the ID signal is output.
• COMPONENT OUT terminal (BNC 3):
Component (Y/B-Y/R-Y) signals are output.
The output level is of ß cam (HIGH).
● Digital signal
• DV IN/OUT terminal: it outputs IEEE1394-
compliant digital video signals.
When a wide screen ID signal exists in the
video signal, the ID signal is output.
● Connection with a monitor TV
A monitor TV can be connected to the MONI-
TOR OUT terminal. Besides the composite
video signals, it also displays the on-screen dis-
play for status or menu screen.
Memo
Set PB/DV IN in the SYSTEM (2/2) Menu
screen according to the signal format of the
tape to be played. (NTSC or PAL)
28
Input
DV
Component
VIDEO
COMPONENT
REMOTE2
LINE
IN
IN
R-Y
B-Y
Y
OUT
AUDIO
CH 1/3
OUT
MONITOR
IN
OUT
OUT
SYNC IN
TIME CODE
IN
OUT
OFF
REC
PLAY
DV
SERIAL
TIMER
SIGNAL
IN/OUT
DC12V
REMOTE
GND
DV
MONITOR OUT (Composite)
Component
– Connecting video signals –
Synchronization signal generator
CH 2/4
IN
OUT
MONITOR
OUT
REMOTE1
Input signal
The input video signal is selected with the IN-
PUT SELECT switch on the front panel. Set
VIDEO INPUT SEL in the VIDEO Menu screen
to select YC input or component input.
● Analog signal
• LINE IN terminal (BNC): composite signal
• Y/C IN terminal (4-PIN): YC separate signal
When a wide screen ID signal is being input,
the ID signal is recorded.
• COMPONENT IN terminal (BNC 3):
The component (Y/B-Y/R-Y) signal.
The output level is of ß cam (HIGH).
● Digital signal
• DV IN/OUT terminal : IEEE1394-compliant
When a wide screen ID signal is being input,
the ID signal is recorded.
Set PB/DV IN in the SYSTEM (2/2) Menu
screen according to the signal format to be
input to the DV terminal. (NTSC or PAL).
Memo
Whether or not to enable SET UP for analog
I/O signals of signals can be selected with SET
UP in the VIDEO Menu screen (for NTSC only).
BB signal
SYNC IN
Monitor
digital video signals
are input.
Advertisement
Table of Contents
