Table of Contents
Advertisement
ON-SCREEN DISPLAY
Alarm display : An alarm message is displayed at the following positions when there has
● "A" display : The state of BR-DV6000 is displayed. It continues to be displayed until the error state is
corrected. This display is not affected by the setting of the display mode.
Display
LOW VOLTAGE
HEAD CLEAN-
ING REQUIRED!
OVERHEATING!
● "B" display : Messages for incorrect operation are displayed for about 3 seconds.
They are displayed when the DISPLAY mode is ON or AUTO.
Display
INVALID TAPE!
LP TAPE!
NO DV SIGNAL
COPY INHIBIT
REC INHIBIT
REC INHIBIT
(NTSC/PAL)
24
been an operation error or when BR-DV6000 is not in good condition,
e.g., dirty head.
3 2 K C H – 1 / 2
A
H E A D C L E A N I N G R E Q U I R E D !
B
0 3 / 0 4 / 0 3
1 1 : 2 0 : 0 0
The voltage of the DC power source is low. If the operation continues, it enters
the Operate OFF mode.
The video head is dirty. Clean it with the head-cleaning tape exclusively for BR-
☞
DV6000. (
Page 8)
If the head is clogged, it is detected in the PLAYBACK mode and this message
is displayed.
The temperature inside BR-DV6000 has exceeded the stated value.
Disconnect the power and place it at a cool place. If this message is displayed
again, BR-DV6000 could be defective.
Consult your JVC-authorized service agent.
Data tape for PCs or DVC PRO tape is used.
The cassette tape will be automatically ejected.
The user attempted to play back a tape recorded in the LP mode.
BR-DV6000 cannot record or play in the LP mode.
The user attempted to record without DV signal input.
The user attempted to record copy-guarded signals.
The user attempted to record on a tape that is not ready for recording (the rear
switch is set to SAVE).
The user attempted to record analog signals when PB/DV IN in the SYSTEM
(2/2) Menu is set to PAL.
S P
0
N O D V S I G N A L
S T A N D B Y - O F F
T C R 0 2 : 0 0 : 0 0 : 0 0
Description
Description
– Alarm display –
0 0
m i n
Advertisement
Table of Contents
