JVC BR-DV6000U Instruction Manual page 12

NAMES AND FUNCTIONS
OF PARTS
Mini
MIC
4
[REMOTE/LOCAL] switch
This switch is used to select how BR-DV6000
is to be operated.
LOCAL : Use this setting if BR-DV6000 is to
be controlled with the key operation
of the unit.
REMOTE : Use this setting if BR-DV6000 is to
be controlled using the edit control-
ler connected to the REMOTE 1 (9-
PIN) terminal or REMOTE 2 (12-
PIN) terminal.
When it is set to REMOTE, settings
can be performed at the REMOTE
(1/2) MENU screen to enable/dis-
able operation via the 9-PIN or 12-
PIN REMOTE terminal.
The 9-PIN REMOTE 1 terminal can
be selected using REMOTE SEL 9
PIN while the 12-PIN REMOTE 2
terminal can be selected with RE-
MOTE SEL JVC.
Memo
● To control BR-DV6000 with the SERIAL RE-
MOTE terminal or DV terminal, this switch set-
ting can be set up with REMOTE SEL SE-
RIAL or REMOTE SEL DV in the REMOTE
(1/2) MENU screen. (
● If it is set to REMOTE, the buttons that can
be operated from the unit are selectable from
LOCAL FUNCTION in the REMOTE (1/2)
MENU screen.
12
MENU RESET
DISP
SEARCH–
SET SEARCH+
HOLD BLANK CUE UP
PHONES REC LEVEL
CH-1/3 CH-2/4
☞
Page 75)
– Front panel – (continued)
A.DUB
PROFESSIONAL
EJECT
COUNTER
CTL
TC
UB
BR-DV6000
9 8 7 6 5 4
5
[INPUT SELECT] switch
This switch is used to select input signals.
DV
LINE
Y/C (CPN) : For inputting the YC separate video
Note
Switching is invalid during recording.
6
[AUDIO OUTPUT] switch
Use this switch to select the audio channel from
the headphone terminal and the AUDIO OUT
terminal located on the rear panel.
This switch is valid in the following conditions.
• During playback of tapes recorded in the 32k
audio mode
• In the EE mode for DV input in the 32k audio
mode
• During audio dubbing
CH-1/2 : For outputting the sound of the
MIX : For outputting the mixed sound of
CH-3/4 : For outputting the sound of CH3 and
OPERATE
REC PLAY PAUSE
REW STOP FF
AUDIO INPUT
MONITOR OUTPUT SELECT REMOTE
L CH-1/2 DV
MIX MIX LINE
R CH-3/4 Y/C
LOCAL
(CPN)
: For DV signals of the DV IN/OUT
terminal (IEEE1394)
: For inputting the composite images
of the LINE IN terminal and ana-
log audio signals.
signal of the Y/C IN terminal and
the component video signal of the
COMPONENT IN terminal. The
selection of the YC separate sig-
nal or the component video signal
can be done with VIDEO INPUT
SEL in the VIDEO MENU screen.
For audio, analog sound is input.
channels CH1 and CH2.
CH1 and CH3 from the CH-1/3 AU-
DIO OUT terminal and the mixed
sound of CH2 and CH4 from the CH-
2/4 AUDIO OUT terminal.
CH4.