Interacting With The Cis Menu - Escort Prism 20401 Reference Manual

3. Press the PAGE HOME key
regularly monitored parameters in the waveform display zone. The display will automatically
return to the Home page if there is no interaction with the CIS softkeys for 90 seconds.
To set up CIS for continuous display in Trace 2:
1. Press the SYSTEM SETUP key to open the System Setup menu.
CLEAR
PT
DATA
2. Press the TRACE SEL softkey to open the following menu.
DISP
VSC
3. Press the TRACE 2 softkey until CIS is highlighted.
4. Press the PAGE HOME key
NOTE:
waveform zone will retain the setting for as long as the monitor is
powered on. Turning the monitor to the STANDBY position, then
back ON, will re-apply all of the monitor's deep configuration
settings. To assign CIS to the Trace 2 waveform zone each time the
monitor is powered on, please consult the service manual for your
monitor.

Interacting with the CIS Menu

Manipulation of the CIS menu can be performed using the softkeys located on the monitor or
through an optional PS/2 keyboard attached to the CIS Communication Module. This interaction
with the CIS menu allows a variety of options including selecting a patient for data collection,
entering the patient's name, and entering manual vital signs data into the patient record, among
others.
To use the monitor softkeys:
1. Access the CIS menu as described previously in section "Accessing the CIS Menu".
2. Once the CIS menu is displayed in the Trace 2 waveform zone, press the softkey adjacent to
the CIS label. The following CIS selections will appear at the bottom of the monitor.
F1
to remove the CIS Menu display and replace the
STORE DISP PT
VS VSC SETUP
TRACE TRACE TRACE
DISP
2 3
OCRG
CIS AUTO AUTO
. The CIS Menu will now display in Trace 2.
The second option for assigning CIS to the Trace 2
F2 F3 F4
9-3
HR
TRACE
AUTO MORE
SEL
ECG
4 MORE
F5