Table of Contents
Advertisement
BioAxs 9750™ Installation & Operations Manual. Version 1.9
Wiring Installation
Door Commander Module (DCM) Connections
DCM Ethernet Connection (LAN)
The BioAxs 9750™ Door Commander Module (DCM) requires a network connection to the
NextgenID Command Center™ server across a 10/100 Mb/s Ethernet network. A standard RJ45
Cat 5 Network Jack is provided on the rear panel of the DCM
Always consult with your NextgenID support representative and/or the local site Network
Note
Administrator before connecting the BioAxs 9750™ system to any existing networks within a
facility to ensure the proper network hardware and software security policies have been
implemented.
DCM Communications Extender
Using the supplied USB host cable, connect the DCM Communications Extender
USB 1 connection on the front panel of the DCM
Access Panel Video
Access Panel video is carried over coaxial cable from the J12 connector on the BioAxs 9750™
Access Panel to the composite video in input located on the rear panel of DCM. Terminate the
coaxial cable with a male RCA video connector. Plug the terminated cable into the composite
video in (access panel video) input on the rear panel of the DCM
BioAxs 9750™ Door Controller Board (DCB) Layout
The figure below shows the rear panel of the BioAxs 9750™ Access Control Panel. The Door
Controller Boards (DCBs) are positioned on the rear of the access panel faceplate in a two-level
design.
Copyright 2005 NextgenID, Inc. All Rights Reserved
(figure
8).
(figure
7)
(figure
8)
(figure
9) to the
28
Advertisement
Table of Contents
