Table of Contents
Advertisement
BioAxs 9750™ Installation & Operations Manual. Version 1.9
Chapter 6: Installation
Door Commander Module Installation
The Door Commander Module (DCM) is an industrial small form factor computer that is included
with each BioAxs 9750™ system. The DCM and BioAxs 9750™ must be located within 100
meters of one another. Operating temperature range for the DCM is 32
Located with the DCM is the DCM Communications Extender, this device is responsible for
relaying communications between the BioAxs 9750™ Access Panel and the DCM. The
Communications Extender plugs directly into an available USB port on the DCM.
The DCM and the DCM Communications Extender should be powered thru an Uninterruptible
Power Supply (UPS) (Battery Backup device rated at least 750 VA.
The following sections layout the typical installation procedures for the DCM unit and associated
devices.
Mount the Door Commander Module (DCM) Unit
Upon choosing the location for the DCM
Mount the DCM in the appropriate configuration (Rack or Wall mount) using the supplied
mounting brackets.
Power On
Indicator LED
Figure 7 DCM Front View
Copyright 2005 NextgenID, Inc. All Rights Reserved
(see Chapter 1: Locating the Door Commander
Power
Switch
°
°
° -
F to 140
F (0
60C).
Module),
USB 2
USB 1
24
Advertisement
Table of Contents
