Table of Contents
Advertisement
BioAxs 9750™ Installation & Operations Manual. Version 1.9
BioAxs 9750™ Access Panel DCB Wiring Connections
The following section details the connections necessary to complete the wiring installation of your
BioAxs 9750™ Access Control Panel.
Jumpers
The various jumper configuration options that are referred to in the following sections utilize 3 pin jumper
terminals requiring the use of 2 pin Jumper caps
505X DCB Standard Connections
505X DCB to 506X DCB Interconnects
The 505X to 506X DCB Interconnections are factory installed. DCB Board interconnects
points are illustrated in figures 13 and 14 above. For additional information, contact a
NextgenID Support Representative.
DCM Communications Extender (J2)
Connect the Shielded Cat5 DCM Communications Extender Cable to the RJ45 connector
on the 505X DCB terminal J2
DCM Communications extender RJ45 connector (J2)
506X DCB Standard Connections
505X DCB to 506X DCB Interconnects
The 505X to 506X DCB Interconnections are factory installed. DCB Board interconnects
points are illustrated in figures 13 and 14 above. For additional information, contact a
NextgenID Support Representative.
Power (J13)
Connect the ground and power leads from the 24VDC Linear Power Supply to the
[GND, 24V] terminals on J13 terminal.
Note It is only necessary to use a single set [GND and 24V] of terminals for this connection.
The remaining [GND, 24V] terminals serve as an auxiliary 24VDC output source for
external devices.
Copyright 2005 NextgenID, Inc. All Rights Reserved
32
Advertisement
Table of Contents
