Elektronika SCM60ZD-S Manual page 69

(2) Rear inlet filter set
(a) Part No.: RBF12
(b) Installation
Do not use this filter set alone.
There are two inlet ports: lower inlet port (normal) and rear inlet port.
1) Detach the rear panel and the hanger metal screwad onto the rear
panel from an indoor unit.
2) Attach the removed hanger metal to the frame of the filter set with small panhead
screws. (One screw each on the right and left sides of the frame is designed to fasten them together onto the main unit).
3) Attach the filter set onto the point where the rear panel was attached with tapping screws. (The rear panel will become of
no use anymore)
(3) Duct joint for air outlet plate
(a) Part No.: RFJ22
This duct joint is to be used for the connection of a round duct (ø 150 mm) to an indoor unit.
(b) Part list
Name
Duct joint
Tapping screws
Heat insulation materials (15
(c) Installation
130
(d) Installation procedure
Use the tapping screws to mount the duct joint to
the front of the indoor unit. Use care to prevent
gaps from forming at the joining surfaces with
the indoor unit. Use insulation at the connecting
areas between a round duct and the duct joint to
prevent condensation.
Qty.
1
8
15 t3) 60
x x
570
310
Round duct connection port
Tapping screws
Indoor unit
Indoor unit
(Flat surface drawing)
215 310 215
130
Duct joint
(8 locations)
Pan-head screw
Filter set
Bracket for filter fixing
Hanger metal
Tappping screw
Unit: mm
230
125
97
Indoor unit
69