Elektronika SCM60ZD-S Manual page 24

(2) Unit ON/OFF button
When the remote control batteries become weak, or if the remote control is lost or malfunctioning, this button may be used to turn
the unit on and off.
(a) Operation
Push the button once to place the unit in the automatic mode. Push it once more to turn the unit off.
(b) Details of operation
The unit will go into the automatic mode in which it automatically determines, from room temperature (as detected by
sensor), whether to go into the cooling, thermal dry or heating modes.
Function
Operation mode
Cooling
Thermal dry
Heating
¡ SKM model
¡ STM model
(3) Drain motor forced operation functions (STM, SRRM only)
(a) Operation
• When the float switch detects drain water, please use the wireless remote control to set the operation mode to "heating",
set the temperature to 30°C, and set the timer to continuous operation.
• When the float switch detects drain water, press the TEST switch on wired remote control for 3 seconds.
(b) Detail of operation
Sets the decision speed to 0 rps, stops the indoor fan motor, and only lets the drain motor run for 5 minutes. After this
operation finishes, if the float switch detects drain water, it will display an error and stop operation.
(C) Reset condition
(i) When the drain motor has run for 5 minutes.
(ii) Use the remote control to set the operation mode to heating, set the temperature to 30°C, and set the timer to something
other than continuous operation.
24
Room temperature
Fan speed
setting
About 25ºC
About 25ºC Auto
About 26ºC
Flap
Timer switch
(SKM, STM only)
Auto Continuous
¡ SRRM model
Unit ON/OFF button
Unit ON/OFF button
Unit ON/OFF button