Elektronika SCM60ZD-S Manual page 48

Drainage
¡ The drain hose must be fit with a downward slope.
¡ Do not set the drain hose like the following illustrations.
Too high The end of the
drain hose is
touching
water.
¡ Pour water in the drain pan below the heat exchanger and confirm that the water is drained outside.
¡ If the extension drain hose is indoors, make sure it is insulated using a shielding pipe (not supplied).
5) Securing the Indoor Unit to the Installation Board
Instalation
board
Wall
Indoor unit
base lower hook
(2) 4-way ceiling cassette type (STM)
(a) Caution for installation
Install at location that meets the following conditons after getting approval from the customer.
1) Where cool air or hot air can easily pass through.
If the height of the location exceeds 3 m, hot air will gather in the ceiling. Suggest to the customer to also install a
circulator.
2) Where there are no wind disturbances to the suction inlet and blowing outlet, where the fire alarm will not be set off
erroneously, where no short circuits occur.
3) Where there is no obstructions to the air flow and where the cooled air can be evenly distributed.
A solid place where the unit or the wall will not vibrate.
4) A place where there will be enough space for servicing.
(Where space mentioned below can be secured)
5) Where wiring and the piping work will be easy to conduct.
6) The place where receiving part is not exposed to the direct rays of the sun or the strong rays of the street illumination.
7) When a sufficient interval cannot be secured between the unit and a wall or another unit, shut up diffusers on that side to
block winds and make sure that no short-circuiting is occurring.
(A wind blocking material is available as an optional part)
sDo not use the unit in the "Lo" wind mode, when winds are blown into two or three directions.
48
It curves like a wave.
the
Shielding pipe
Drain hose
when a part of the extension drain hose is indoors
Indoor unit
Installation
board
Hook (2 locations)
under 5 cm
Smell from
sewerage drains.
The gap to the The end of the
ground is less drain hose is
than 5 cm. touching
sewage drains.
Extension drain hose
the
Installing steps
1. Hook the upper part
of the indoor unit to
the installation board.
2. The unit can be in-
stalled simply by
gently pushing in the
lower part.