Configuring The Network - Network Menu - Sony Ipela SNCA-ZX104 User Manual

Note
When you click OK next to Browse..., the camera list is
immediately updated. It is unnecessary to click OK at
the bottom of the screen.
To edit the camera list
Set the IP address and port number for each camera
number.
Camera No.: Select from camera 1 to 255.
IP address: Display the selected camera's IP address.
Click to input the value.
Port: Display the selected camera's port number. Click
to input the value.
Set: When clicked, the entered address and port number
values are applied to the selected camera if there are
no errors for either value.
Delete: When clicked, the selected camera's IP address
and port number settings are deleted.
Note
When you click Set, the selected camera's settings are
immediately updated in the camera list, but these
settings are not saved until you click OK at the bottom
of the screen.
OK/Cancel
See "Buttons common to every menu" on page 15.
18
Configuring the Network — Network Menu
Configuring the Network
— Network Menu
When you click Network in the Setup menu, the
Network menu appears.
Use this menu to configure the network to connect the
unit and the computer.
MAC address
Displays the MAC address of the system.
Ethernet status
Displays the current transmission rate.
IPv4 setting
Configure the IPv4 network setting.
IP address
Configure the IP address.
Obtain an IP address automatically (DHCP): Select
this option when a DHCP server is installed on the
network to allow IP address assignment. With this
setting, the IP address is assigned automatically.
Use the following IP address: Select this option when
you set a fixed IP address. With this setting, specify
the IP address, Subnet mask and Default gateway
manually.
Note
When you select Obtain an IP address automatically
(DHCP), make sure that a DHCP server is operating on
the network.
IP address
Type the IP address of the system.
Subnet mask
Type the subnet mask.