Format Card - Brady BP-PR PLUS series Configuration Instructions

BP-PR PLUS series
Memory cards
8.4.4

Format card

You can delete all data from a memory card with the Format card function. This reformats the memory
card. This is why you can also use the Format card function if the Unknown card or Structural
err. error message was output when using the card.
You can prevent unauthorized deleting of memory cards by using a PIN (see "4.1.6" on Page 27).
1. Insert a memory card (see "8.1" on Page 56).
2. Press the menu button.
3. Select Memory card > Format card with the buttons
4. Press the ↵ button.
A selection field with the selection No appears in the display.
5. Use the
6. Press the ↵ button.
7. If the function Format card is protected via a PIN, use the buttons
number and confirm with the ↵ button.
The deleting procedure starts.
8. Do not remove the card from the printer during the deleting procedure.
The memory volume of the card is shown in the display as soon as the deleting procedure is com-
plete.
9. Press any button.
8.4.5 Printing file contents
The label files found on a memory card consist of a sequence of printer commands. You can print these
command sequences in the form of text with the ASCII dump (Card) function.
1. Insert printable medium (labels, endless paper) which extends across the entire printing width.
2. If the printout is to occur using thermal transfer printing, insert transfer ribbon with the maximum
width.
3. Insert a memory card (see "8.1" on Page 56).
4. Press the menu button.
5. Select the ASCII dump (Card) function in the Memory card menu.
6. Press the ↵ button.
The index of the memory card is shown in the display.
7. Select the desired label file in the index of the card with the
8. Start printout with the ↵ button.
The data printout is started after four lines are received. For this reason, it is often necessary to call
up the last few lines of a label description with the feed button.
You can cancel the printout of the label description with the cancel button.
60
and buttons to select Yes.
Configuration Instructions
and .
, , and to enter the code
and buttons.
Edition 3/07