Brady BP-PR PLUS series Configuration Instructions page 32

BP-PR PLUS series
Configuration
The following parameters for the Ethernet interface can only be accessed via the printer website:
Parameter
SMTP server
Raw-IP port
LPD
SNMP
Time server
Tab. 14: Additional parameters for Ethernet interface
32
Meaning
E-mails can be sent to selected addresses when certain status and error
messages are generated. To activate:
⇒ Set parameter to "On".
⇒ Enter IP address of the SMTP server.
⇒ Enter a valid e-mail address for the printer in the "From address"
field.
More detailed information on sending e-mails is found in "System mes-
sages tab" on Page 33.
Service for printing on the network (see "2.2.1" on Page 16).
⇒ Select a predefined port address.
Activation of the network printing service LPD (see "2.2.1" on Page 16):
⇒ Set parameter to "On".
⇒ Enter "lp" as the queue name.
Data exchange between printer and management station via SNMP
(Simple Network Management Protocol). To activate:
⇒ Set parameter to "On".
⇒ Enter IP address of the management station(s) (receiver 1 or
receiver 2).
⇒ Assign the "Community" parameter the value "public".
Synchronization of the date and time of the printer. To activate:
⇒ Set parameter to "On".
⇒ Enter IP address of the time server.
Synchronization occurs hourly. The accepted time is not automatically
saved in the printer, however. To save the accepted time:
⇒ Call up the parameter time and save the displayed setting with OK.
Configuration Instructions
Default
Off
9100
Off
Off
Off
Edition 3/07