Brady BP-PR PLUS series Configuration Instructions page 33

BP-PR PLUS series
Configuration
System messages tab
Status and error messages can be sent automatically to the SNMP manager or via e-mail to the selected
addresses immediately after they occur via the Ethernet interface. You can select the messages to be
sent and the destination addresses on the "System messages" tab.
Fig. 9: "System messages" tab on the printer website
Column Meaning
Description Status and error messages that can be sent.
⇒ Expand tree structure by clicking the circular symbol once or double-clicking the description.
An entry for a higher-order description (e.g. note) is automatically accepted for all subordinate
descriptions (e.g. "Start", "Not ready", "Ribbon running out").
SNMP 1 Management stations on local network which communicate with the printer via SNMP. To make
use of SNMP functionality, the SNMP agent must be activated (see "2.2" on Page 15).
SNMP 2
⇒ Select management station by clicking the corresponding cell.
The selection is indicated via a symbol. You can undo the selection by clicking it again.
E-mail Valid e-mail address for the SMTP server to which the message is to be sent.
⇒ Click cell and enter e-mail address or select from pull-down menu.
Sound Audible signal which indicates receipt of the message.
⇒ Click cell and select signal type in pull-down menu.
Tab. 15: Parameters on "System messages" tab
The settings are not accepted until the Transfer button is clicked. If you switch to another tab before-
hand, the settings are lost.
Edition 3/07 Configuration Instructions 33