System (If So Equipped); Ski/Wake Board Post (If So Equipped); General Inspection And Cleaning - Sea-doo GTX 4-TEC 6159 Operator's Manual

Main Fuse besides MPEM
2
F18H1CY
1. MPEM
2. Main fuse
2°
F18H1DY
To remove fuse, lift tab while pulling
holder out. Pull fuse out using cover on
MPEM as shown above.
To remove fuse, lift tab then pull holder
out. Pull fuse out using cover on MPEM
as shown above.
Reassemble removed parts.
1
1°
www.SeaDooManuals.net
O.P.A.S. System
(if so equipped)
The O.P.A.S. system operation and
condition should be checked by an au-
thorized SEA-DOO dealer.
Ski/Wake Board Post
(if so equipped)
Check ski/wake board post operation.
Ensure it slides up and down easily.
Check locking mechanism operation.
Check fasteners tightness. If some-
thing is found defective, don't use
ski/wake board post and see an autho-
rized Sea-Doo dealer for repair.
General Inspection and
Cleaning
Inspection
Check engine compartment for any dam-
age and for leaks of fuel, coolant or oil.
Ensure all hose clamps are properly se-
cured and no hose is cracked, kinked or
presenting any other damage.
WARNING
If any gasoline leak and/or odor are
present, do not start the engine.
Have the watercraft serviced by an
authorized Sea-Doo dealer.
Inspect muffler, battery, fuel tank and
oil reservoir fastening devices. Visually
check electrical connections for corro-
sion and tightness.
Inspect hull and jet pump water intake
grate for damage. Replace or have dam-
aged parts repaired.
WARNING
Periodically verify the seat lock pin
and tighten if needed. Make sure
seat securely latches.
77