Table of Contents
Advertisement
Quick Start Guide
The Rear Ports
Port
Power Switch
1
PWR
2
3
RESET
LAN
1X
─
4
(RJ-45 connector)
Phone
1X
─
5
(RJ-11 connector)
LINE
6
ADSL
7
Antenna
8
4
TLK/800VGT-v2.5-080523
The Ethernet Port # 4 can be used as a console port. You need the special
Ethernet serial adapter, included in this package to connect the LAN cable of
Port 4 to a PC's RS-232 port (9-pin serial port). Note that the console port is for
emergency use only, and should not be used by default.
4X
2X
Power ON/OFF switch
Connect the supplied power adapter to this jack.
After the device is powered on, press it to reset the
device or restore to factory default settings.
1-3 seconds: reset the device
6 seconds and above: restore to factory default settings
(this is useful when you have forgotten the router's
administrative password).
Connect an Ethernet network cable (yellow) to one of the
four LAN ports when connecting to a PC or an
office/home network.
Connect RJ-11 ("telephone") cable (grey) to these ports
when connecting to a telephone handset.
Connect a supplied RJ-11 ("telephone") cable (green) to
this port when connecting to the PSTN telephone network
(the "LINE" port on the splitter).
Connect a supplied RJ-11 ("telephone") cable (red) to this
port when connecting to the ADSL network (the "ADSL"
port on the splitter).
Connect the detachable antenna to this connector.
Meaning
Advertisement
Table of Contents
