Changing The Final Transmission Oil - Yamaha YP250R 2005 Service Manual

CHANGING THE FINAL TRANSMISSION OIL

1
2
CHANGING THE ENGINE OIL/
15.Reset:
• oil change indicator
M MMM
a. Set the main switch to "ON" while holding
the "MODE" and "SET" buttons pushed for
two to five seconds.
b. Release the buttons and the oil change indi-
cator will go off.
NOTE:
If the engine oil is changed before the oil
change indicator comes on (i.e., before the
periodic maintenance and lubrication interval
has been reached), the oil change indicator
must be reset as soon as possible so that it
comes on for the next periodic maintenance
and lubrication interval.
L LLL
16.Install:
• footrest board
• storage box
Refer to "COVERS AND PANELS".
CHANGING THE FINAL TRANSMISSION
OIL
1
1. Stand the vehicle on a level surface.
NOTE:
• Place the vehicle on a centerstand.
• Make sure that the vehicle is upright.
2. Start the engine, warm it up for several min-
utes, and then turn it off.
3. Place a container under the transmission oil
drain bolt.
4. Remove:
• final transmission oil filler cap 1
• O-ring 2
• transmission oil drain bolt 3
5. Drain:
• final transmission oil
(completely from the transmission case)
3 - 24
M MMM M M MMM M M MMM M
L LLL L L LLL L L LLL L
CHK
ADJ
M MMM M M MMM M MMM
L LLL L L LLL L LLL