Final Transmission Oil - Yamaha Xenter 125 2011 Owner's Manual

9. Start the engine, and then let
it idle for several minutes while
checking it for oil leakage. If oil is
leaking, immediately turn the en-
gine off and check for the cause.
10. Turn the engine off, and then
check the oil level and correct it if
necessary.
To reset the oil change indicator
and oil change tripmeter
TIP
The oil change indicator and oil
change tripmeter can be reset when
"OIL CHANGE" and "OIL TRIP" ap-
pear in the multi-function display. (see
page 3-3.)
PERIODIC MAINTENANCE AND ADJUSTMENT

Final transmission oil

The final transmission case must be
checked for oil leakage before each
ride. If any leakage is found, have a
Yamaha dealer check and repair the
scooter. In addition, the fi nal transmis-
sion oil must be changed as follows at
the intervals specified in the periodic
maintenance and lubrication chart.
1. Start the engine, warm up the fi -
nal transmission oil by riding the
scooter for several minutes, and
then stop the engine.
2. Place the scooter on the center-
stand.
3. Place an oil pan under the final
transmission case to collect the
used oil.
6-12
EAU20065
1
1. Final transmission oil fi ller cap
4. Remove the fi nal transmission oil
filler cap and its O-ring from the
fi nal transmission case.
5. Remove the fi nal transmission oil
drain bolt and its gasket to drain
the oil from the fi nal transmission
case.
EAU1722A
1
2
3
4
5
6
7
8
9