Final Transmission Oil - Yamaha BWS 2003 Owner's Manual

1
ZAUM0153
1. Final transmission oil drain bolt
2. Final transmission oil filler cap

Final transmission oil

The final transmission case must be
checked for oil leakage before each
ride. If any leakage is found, have a
Yamaha dealer check and repair the
scooter. In addition, the final transmis-
sion oil must be changed as follows at
the intervals specified in the periodic
maintenance and lubrication chart.
1. Start the engine, warm it up by
riding the scooter for several mi-
nutes, and then stop the engine.
2. Place the scooter on the
centerstand.
PERIODIC MAINTENANCE AND MINOR REPAIR
3. Place an oil pan under the final
2
transmission case to collect the
used oil.
4. Remove the oil filler cap and drain
bolt to drain the oil from the final
transmission case.
5. Install the final transmission oil
drain bolt, and then tighten it to
the specified torque.
Tightening torque:
Final transmission oil drain bolt:
EAU04228
17 Nm (1.7 m
6. Add the specified amount of the
recommended final transmission
oil, and then install and tighten the
oil filler cap.
Recommended final transmission oil:
See page 8-1.
Oil quantity:
0.11 L
•
•
7. Check the final transmission case
kgf)
•
6-6
Make sure that no foreign
material enters the final trans-
mission case.
Make sure that no oil gets on
for oil leakage. If oil is leaking,
check for the cause.
EWA00062
6