Front Wheel - Yamaha XVS65A Owner's Manual

PERIODIC MAINTENANCE AND ADJUSTMENT

Front wheel

To remove the front wheel
WARNING
To avoid injury, securely support the
vehicle so there is no danger of it
falling over.
1. Disconnect the speedometer ca-
ble from the front wheel.
7
1. Speedometer cable
2. Loosen the front wheel axle pinch
bolt, then the wheel axle.
EAU24360
EAU24601
EWA10821
1. Wheel axle
2. Front wheel axle pinch bolt
3. Lift the front wheel off the ground
according to the procedure on
page 7-33.
4. Pull the wheel axle out, and then
remove the wheel. NOTICE: Do
not apply the brake after the
wheel has been removed to-
gether with the brake disc, oth-
erwise the brake pads will be
forced shut.
To install the front wheel
1. Install the speedometer gear unit
into the wheel hub so that the pro-
jections mesh with the slots.
2. Lift the wheel up between the fork
TIP
Make sure that there is enough space
between the brake pads before insert-
ing the brake disc and that the slot in
the speedometer gear unit fits over the
retainer on the fork leg.
1. Speedometer gear unit
2. Speedometer cable
3. Retainer
[ECA11071]
3. Insert the wheel axle.
4. Lower the front wheel so that it is
EAU24933
5. Tighten the wheel axle to the spec-
7-34
legs.
on the ground, and then put the
sidestand down.
ified torque.