Mitsubishi Electric Mr.SLIM PUHZ-RP1.6VHA Technical & Service Manual page 95

OPERATING PROCEDURE
13. Removing the motor for compressor (MC)
(1) Remove the service panel. (See figure 1.)
(2) Remove the top panel. (See figure 1.)
(3) Remove 2 front cover panel fixing screws (5
remove the front cover panel. (See photo 3.)
(4) Remove 2 back cover panel fixing screws (5
remove the back cover panel.
(5) Remove the electrical parts box. (See photo 3.)
(6) Remove 3 valve bed fixing screws (4
and stop valve fixing screws (5
valve bed.
(7) Remove 3 right side panel fixing screw (5
of the unit and then remove the right side panel.
(8) Remove 3 separator fixing screws (4
the separator.
(9) Collect the refrigerant.
(10) Remove the 3 points of the motor for compressor fixing
nut using a spanner or a monkey wrench.
(11) Remove the welded pipe of motor for compressor inlet
and outlet and then remove the compressor.
Note: Collect refrigerant without spreading it in the air.
14. Removing the power receiver
(1) Remove the service panel. (See figure 1.)
(2) Remove the top panel. (See figure 1.)
(3) Remove 2 front cover panel fixing screws (5
remove the front cover panel. (See photo 3.)
(4) Remove 2 back cover panel fixing screws (5
remove the back cover panel.
(5) Remove the electrical parts box. (See photo 3.)
(6) Remove 3 right side panel fixing screw (5
rear of the unit and then remove the right side panel.
(7) Collect the refrigerant.
(8) Remove 4 welded pipes of power receiver inlet and outlet.
(9) Remove 2 receiver leg fixing screws (4
Note: Collect refrigerant without spreading it in the air.
10) and
10) and
10) and 4 ball valve
16) and then remove the
10) in the rear
10) and remove
10) and
10) and
10) in the
10).
95
PHOTOS
Photo 12
Power
receiver
Valve bed
Separator
Separator
fixing screw
Compressor
fixing nut
Photo 13
Inlet
Power
receiver
Separator
Valve bed
fixing
screws
Motor for
compressor
(MC)
Outlet
Four-way
valve