Sound Adjustments; Attenuating The Input Signal; Adjusting The Front Speakers Output Balance - JVC LVT0858-001A Instructions Manual

Sound Adjustments

You can also use the remote control for some sound adjustments.
• When using the remote control, see also "Mastering Remote Operations" on page 38.
STANDBY
STANDBY/ON
PHONES

Attenuating the Input Signal

When the input level of the analogue source is too high, the sounds
will be distorted. If this happens, you need to attenuate the input
signal level to prevent the sound distortion.
• You have to make this adjustment for each analogue source.
Press and hold INPUT ATT (INPUT ANALOG/
DIGITAL) so that the INPUT ATT indicator lights
up on the display.
• Each time you press and hold the button, the Input Attenuator
turns on ("ATT ON") or off ("ATT NORMAL").
INPUT
ANALOG/DIGITAL
INPUT ATT
ANALOG L R
INPUT ATT
Adjusting the Front Speakers
Output Balance
If the sounds you hear from the front right and left speakers are
unequal, you can adjust the speakers output balance.
• You have to make this adjustment for each source.
Before you start, remember...
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 1 again.
1
Press ADJUST.
The CONTROL buttons now work for sound
ADJUST
adjustments.
20
CONTROL
5/∞/3/2
Display
TV DIRECT
DVD STB
CONTROL
ANALOG L C R
LPCM DSP
SUBWFR LFE
DOLBY D AUTO SR
LS S RS
DTS INPUT ATT
SETTING ADJUST MEMORY
DVD STB
ADJUST
Remote
NOT
Remote
NOT
INPUT ATT
HOME CINEMA CONTROL CENTER
VCR TV TAPE FM/AM
PL ΙΙ
SLEEP AUTO MODE TA HEWS INFO RDS TUNED ST AUTO MUTING
HP
MH
Z
KH
Z
INPUT
VOL
ANALOG/DIGITAL
VCR TV TAPE FM/AM INPUT ATT
2
Press CONTROL ∞ (or 5) repeatedly until
"BAL (Balance)" (with the current setting)
appears on the display.
CONTROL
R
T
* "CENTER" is the initial setting. If you have already changed
the setting, another setting will be shown.
3
Press CONTROL 3 (or 2) to adjust the front
speaker balance.
CONTROL
PR ΙΙ
ANALOG L C R
LPCM DSP
SUBWFR LFE
VOL
DOLBY D AUTO SR
LS S RS
DTS INPUT ATT
• Pressing CONTROL 3 decreases the left channel output
(from CENTER to L –21).
• Pressing CONTROL 2 decreases the right channel output
(from CENTER to R –21).
SURROUND SURROUND
ON/OFF MODE
MASTER VOLUME
*
VOL
VOL