AQUAPHOR DWM-101 Installation Manual

AQUAPHOR DWM-101 Installation Manual

Drinking water machine

Advertisement

Drinking Water Machine
AQUAPHOR DWM-101

INSTALLATION GUIDE

VERSION 1.2
System Tested and certified by NSF International against NSF/ANSI
Standard 58 for the reduction of claims specified on performance data sheet.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the DWM-101 and is the answer not in the manual?

Questions and answers

Summary of Contents for AQUAPHOR DWM-101

  • Page 1: Installation Guide

    Drinking Water Machine AQUAPHOR DWM-101 INSTALLATION GUIDE VERSION 1.2 System Tested and certified by NSF International against NSF/ANSI Standard 58 for the reduction of claims specified on performance data sheet.
  • Page 2 OWNER INFORMATION registration card must be completed and returned by through this product contains bacterial iron, algae, Safety Instructions the original owner to the warrantor, AQUAPHOR sulphur, tannins, organic matter, or other unusual ® Service Log within 30 days of installation. P.O. Box 298, Groveport,...
  • Page 3: Safety Instructions

    Owner Information Introduction to Drinking Water Machine Safety Instructions Drinking Water Machine (DWM) operates by removing contaminants from water at the molecular level. By using your household water pressure to squeeze your water against a special membrane, water molecules are separated from impurities. Rejected dissolved solids are automatically rinsed down the drain leaving only Warning: This appliance must be applied to potable water only.
  • Page 4: Drinking Water Machine Filter Labels

    Drinking Water Machine Appliance Drinking Water Machine Filter Labels Figure 2: AQUAPHOR Drinking Water Machine Appliance ® Replacement filter cartridge K5 (black tab) – (1) – Reduces suspended and particulate matter 5 microns* or larger from the incoming water to protect Replacement filter cartridge K2 (2) and RO membrane (3) from clogging.
  • Page 5: Recommended Filter Maintenance

    Installation and Maintenance Information Recommended Filter Maintenance The frequency in which the membrane and filters should be replaced depends upon the quality of the water Checklist Before Installation that enters the appliance. Every three to six months filter 1 and every six months filters 2, 4 should be replaced, and every year filter 3 should be replaced (see Table on page 7).
  • Page 6: Installation Tool List

    With the collet held in this position, the tube can be removed. Figure 3: Drinking Water Machine Flow Diagram *The Drinking Water Machine has been pressure tested. However, due to shipping vibrations, AQUAPHOR recommends ®...
  • Page 7 Installation Steps and Start-Up Procedures, Cont. Installation Steps and Start-Up Procedures, Cont. Step 3 Prepare the Sink for Spigot Installation Step 5 Install the Incoming Water Supply Valve The most convenient installation would allow the use of an existing spray attachment hole. If the spray For installation with standard angle stop incoming water supply valve.
  • Page 8 Installation Steps and Start-Up Procedures, Cont. Installation Steps and Start-Up Procedures, Cont. Step 7 Connecting the Tubing Procedure Step 6 Install the Drain Saddle Assembly To connect the tubing, remove the red locking clip and wet the The drain assembly should be installed above the end of the tubing with water.
  • Page 9 After the storage tank is filled up for the seventh time, the water is now ready to use. Important: To maintain Install cartridges in “Start” Position (See table 1). the highest quality of water, AQUAPHOR recommends that if the treated water is not used for a week, open the ®...
  • Page 10: Maintenance Procedures

    Maintenance Procedures Maintenance Procedures, Cont. Warning: Shut off water to the appliance before beginning any maintenance. Checking and Replacing the I/O Valve Assembly Caution: Drain the tank by opening the treated water spigot before disconnecting the tubes or before removing A.
  • Page 11: Assembly And Parts

    Remove the decorative cover from the appliance. Remove the I/O Valve assembly. Disconnect the blue tube from the water fitting at top center of the storage tank. Using the Tank Flange Key provided by AQUAPHOR , unscrew the plastic component on top of the storage ®...
  • Page 12 Assembly and Parts, Cont. Assembly and Parts, Cont. Air Gap Spigot Assembly (Lead Free) DWM Assembly Figure 17: DWM Assembly Part # Description Quantity 10015 Input/Output Valve assembly 10020 Valve Assembly Figure 16: Air Gap Spigot Assembly (Lead Free)* (treated water spigot) Part # Description Quantity...
  • Page 13: Troubleshooting

    Specifications Troubleshooting If the appliance experiences difficulties, use the Appliance Shutoff Valve to shut off the incoming water to the Model Part # AQUAPHOR DWM-101 appliance. RO Membrane (3) Production Rates Problem Possible Cause Solution Gallons per day 52.5 52.5...
  • Page 14 Notes Notes 10/9/2013 Drinking Water Machine Drinking Water Machine 10/9/2013 Installation Guide Installation Guide...
  • Page 15 Drinking Water Machine AQUAPHOR DWM-101 P.O. Box 298, Groveport, OH 43125 Phone: 614-836-9422. Fax: 614-836-9876 © 2013...

Table of Contents