Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for AQUAPHOR RO-312S PRO
Summary of Contents for AQUAPHOR RO-312S PRO
- Page 1 OPERATION MANUAL OSMO PRO AQUAPHOR RO-312S REVERSE OSMOSIS SYSTEM...
- Page 2 Reverse osmosis system Aquaphor RO-312S Pro (hereinafter referred to as RO-312S Pro) is manu- factured by WestAqua Invest OÜ (Estonia). RO-312S Pro is intended to purge of mechanical and colloidal particles, organic impurities and to remove foreign flavour, odour and colour when post-treating cold drinking water supplied via municipal and local water supply networks (water from artesian boreholes, wells, etc.) to meet the...
- Page 3 Cartridges RO-100S RO-100S. PRE-FILTER 2 IN 1 MEMBRANE CARTRIDGE Filters the sand, the iron. • Absolute softening of the water. • Eliminates all harmful impurities. Filters the water in two steps: • Eliminates bacteria and viruses.* • mechanical filtration from 10 microns; •...
-
Page 4: Specifications
(depending on salinity and water temperature) The ratio of purified and drainage water (at a temperature of water at the inlet to RO-312S Pro not lower than +20 °С and at a pressure (1:4–1:6) not less than 0.2 MPa) Weight, no more... - Page 5 The principle of operation of the RO-312S Pro The collector block consists of a base on which there are three collectors for connecting replace- able filter cartridges, automatic valves and two grooves for attaching to the wall. The collector block is closed by a decorative protective cover. The collector block is equipped with a black tube designed to drain drainage water.
- Page 6 110 mm from each other 4. Install a connection unit (5) between the cold at the installation site of the RO-312S Pro. Fix water supply system and the flexible con- the collector block so that with installed car- nection of the mixer.
- Page 7 10. Insert the free end of the tube extending from diagram the clean water tip into the stand hole (8). Establish a stop: from the bottom of the tab- 12. Flare nut letop put on the free end of the tube a sleeve 13.
-
Page 8: Connecting Tubes
NOTE There is no need to install a membrane sleeve, insert the end of the tube pre-wetted cartridge at this point. To flush the RO-312S Pro, with water into the fitting sleeve until it stops at screw the flushing plug into the middle slot of a depth of about 15 mm, and reinstall the clip. -
Page 9: Operation
312S Pro daily for leaks. In the first week of opera- transportation, which must be washed off when tion of the RO-312S Pro, when switching the au- the water purifier is first started. tomatic valve, noise may be observed associated... -
Page 10: Cutter Operation
• Open the inlet crane and make sure that the RO-312S Pro connections are tight. Replacing K1 and K7M Cartridges Replacing a RO-100S Cartridge • Close the inlet valve on the connection unit and connect the tip to the storage tank to re- •... -
Page 11: During Operation
RO-312S mechanical filters, etc.) if the source Pro to the water supply network your- water significantly differs from the self. To connect the RO-312S Pro, it is requirements of national standards recommended to contact the service for drinking water. -
Page 12: Exclusions And Limitations
You may have other rights which vary from Reverse osmosis system Aquaphor, Model state to state. RO-312S Pro – Two Year Warranty from the date of purchase. This does not apply, however, to THIS WRITTEN WARRANTY IS THE ONLY consumable filters. -
Page 13: Fault Table
** the pre-treatment cartridges. Please, replace exhausted filter cartridges in a timely manner. every 1–3 months if water entering your RO-312S Pro does not meet sanitary standards (with a high content of mechanical impurities). The RO-312S Pro shelf life (with a set of replace-... - Page 16 RO-312S The manufacturer reserves the right to make improvements to the design REVERSE OSMOSIS SYSTEM of the Aquaphor RO-312S Pro without being mentioned in this Manual. The date of manufacture and quality control is indicated on the product serial number label.
Need help?
Do you have a question about the RO-312S PRO and is the answer not in the manual?
Questions and answers