AQUAPHOR RO-206S Operation Manual
  1. Manuals
  2. Brands
  3. AQUAPHOR Manuals
  4. Water Filtration Systems
  5. RO-206S
  6. Operation manual

AQUAPHOR RO-206S Operation Manual

Reverse osmosis system
Hide thumbs
Table of Contents

Advertisement

Quick Links

RO -2 0 6 S
REVERSE OSMOSIS SYSTEM
Operation manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the RO-206S and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for AQUAPHOR RO-206S

Summary of Contents for AQUAPHOR RO-206S

  • Page 1 RO -2 0 6 S REVERSE OSMOSIS SYSTEM Operation manual...

  • Page 2: Specification Data

    RO-206S Reverse Osmosis System (hereinafter referred to as RO-206S) is manufactured by Westaqua-Invest OÜ (Estonia). RO-206S is intended to purge of mechanical and Dirty water colloidal particles, organic impurities and to remove foreign flavour, odour and colour when post-treating cold...
  • Page 3 3. Scope of Delivery (Fig. 1): № Name Quantity RO-206S housing assembly (1) 1 pc. Cartridges: Pre-treatment unit: 2.1.1 K1 replaceable filter cartridge (3) 1 pc. 2.1.2 К2 replaceable filter cartridge (2) 1 pc. Reverse-osmosis membrane unit: 2.2.1 Replaceable membrane cartridge (3, 4) 2 pcs.
  • Page 4 ATTENTION! The RO-206S performance depends on the pressure in the water supply sys- tem. No proper operation of RO-206S is guaranteed at pressures below 90 kPa in the water supply system.
  • Page 5 5. RO-206S Installation ATTENTION! It is not recommended to independently connect RO-206S units to the water supply network. Only authorized specialists should install RO-206S units. Tap for treated water Kitchen faucet Sink drain Drain clamp 1/4” treated water tube (blue)
  • Page 6 Installation of the connecting assembly* • Turn water off at the mainline. • Open the kitchen faucet to relieve pressure in the water supply system. The inlet cock is in its closed position • Unscrew the clamping nut from the flexible hose in the cold water supply line to the faucet.
  • Page 7 • Check that the tube (10) is tight. The tube should not be pulled out using a force of 80-100 N. ATTENTION! It is recommended to use the stand- ard RO-206S tap for treated water. Using other taps may result in humming and other unusual sounds.
  • Page 8 The cartridge life indicator lights blink (the light signal is followed by an audible signal). • On the front panel of your RO-206S (Fig. 13), Fig. 10a Fig. 10b flash the PUSH button 3 times to start the flushing mode.

  • Page 9: Replacing Cartridges

    • Wait for the water to flow from the tap for treated water. • Let the water through your RO-206S for 1 hour.* Fig. 13 • Close the treated water tap. • Fill and empty the storage tank 2 more times.
  • Page 10 The solid indicators of the filtration units inform time, informing that your RO-206S is connected to about the unexpired service life of the cartridges. the power supply. Light indicator 5 (see Fig. 15) starts flashing in the event of a malfunction; it stays solid the rest of the...

  • Page 11: Storage Tank Maintenance

    • Make sure the RO-206S connections are tight. followed by a sound signal. The other indicators • Let the water through your RO-206S for 1 hour are solid. • Close the treated water tap.

  • Page 12: Storage And Transportation Rules

    80%. water quality. It is forbidden to turn the RO-206S over, to hit or • It is recommended to use RO-206S as a post- to expose to other mechanical stresses. treatment unit for microbiologically safe water,...

  • Page 13: Exclusions And Limitations

    Do not immerse your RO-206S, as well as the power supply unit, the power cord and the plug of the power cord in water or other liquid, or wash them with running water or in a dishwasher.
  • Page 14 Service life (operating time) of replaceable products. filtering cartridges: • Damage or loss resulting from acts which are Service life not the fault of Aquaphor or which the Product Name (operating time) is not specified to tolerate. Pre-treatment unit 4. This warranty gives you specific legal rights.

  • Page 15: Fault Table

    The power supply plug is Insert the power supply plug not plugged into the coaxial into the coaxial connector of connector of the RO-206S. the RO-206S The inlet cock of the Open the inlet cock of the connecting assembly is connecting assembly closed.
  • Page 16 Corp., L. Tolstoi 2A, Sillamäe, Estonia, 40231. www.aquaphor.com The manufacturer reserves the right to make improvements to the design of the RO-206S without being mentioned in this Manual. The date of manufacture and quality control is indicated on the product serial number label.

Table of Contents