Removing The Blower Housing And Fan Blade - Frigidaire 27" Dryers with electronic controls Service Manual

2. Disconnect the wires from the thermistor and re-
move the two screws holding the thermistor to the
blower housing.

Removing the blower housing and fan blade:

1. Disconnect the dryer from electrical supply and
remove the drum.
2. Remove the control thermistor.
3. Using a 7/8" socket turn the fan blade clockwise
while holding the motor shaft to remove the blade
from the motor shaft.
4. Remove two screws holding the housing to the dryer
base.
5. Remove the front motor lock by inserting a screw-
driver at the rear of the housing to release the
housing from the motor.
6. Raise the front of the motor and pull the housing
forward.
67